Then, when you turn it on, you need to pay attention to the inscription: Press X to setup.
Install the prepared drive in any of the rectangular connectors of the personal computer. But in order to start the process of installing the operating system, you need to properly configure the BIOS of the personal computer. Preparing to install the operating systemĪt the next stage, you no longer have to use the UltraIso program. Otherwise, it will not be possible to create a bootable drive, and the operating system will issue a corresponding message.
This nuance must be taken into account without fail. That is, if the image occupies 4.4 GB, then the drive in this case should be at least 8 GB. Do not forget that the size of the flash drive should be more than the operating system installer. This will make it easier to identify it in the BIOS at the next stage.Īfter the end of the manipulations, the process can be considered complete, and now you can easily install the operating system from the USB flash drive.
Also do not forget to set a volume label.
How to create a bootable USB flash drive? After the installation is complete, the order of the operation will be as follows. After that UltraIso is ready to work.Ĭreating a bootable flash drive using the UltraIso program There is no need to perform any additional configuration for creating a bootable drive. Follow the instructions of the wizard, install this program on your local computer. The remaining versions are not recommended, because their performance leaves much to be desired.
First you need to download this program from the official site. Creating a bootable flash drive without this step is impossible. Therefore, most users are recommended to take the first modification of UltraIso.įirst you need to download and install UltraIso. She has more options, but to create such a flash drive its purchase is not justified. Some functions are not available in it, but the ability to create bootable flash drives is present. Therefore, it is necessary to pay attention to this. Although rare, but there are times when this important option is missing in the installation version. It is important that the source of the installer is autoloaded. To do this, install it in the drive, run UltraIso, press "F8" and, following the instructions, create a copy on the hard disk of the installation version of the operating system.
iso format (that is, the file should have such an extension). Its demo version can be downloaded from the Internet.
Therefore, this way of installing system software is the future.īefore you make an UltraIso bootable USB flash drive, you need to select the correct installation version of the operating system. Data from a flash drive is transmitted faster than from a CD. At the same time, the installation speed of the operating system will be several times higher. So with the connection of the flash drive there will be no problems. All modern computers without exception are equipped with a USB connector.
In general, this is a universal solution for all cases. But, again, this does not mean that this method can not be applied to a stationary personal computer (not on every system unit you can now find a device for reading CDs) or a laptop. First of all, these are some models of ultrabooks and all netbooks. A bootable USB flash drive allows you to install the operating system on a computer that does not have a drive for reading and writing CDs. In which cases without such a flash drive can not do?įirst, let's define the cases when you can not do without this important feature of UltraIso. It is the algorithm for performing this operation and will be discussed later. A bootable flash drive with it is created without problems. Within the framework of this article, a key feature of the UltraIso program is described.